MFT GH201B slide-in Toggle Clamp Benchdog Adapter 19 / 20mm

This is a slide-in base for GH201B toggle clamps for 19 and 20mm benchdog holes

You can slide your toggle clamp in the slot, so no screws are needed.

PLA, print orientation as it comes from the STL file, use supports and 100% infill, this is just twice as much material as with 25% infill but makes a huge difference in stability!

Caution: While the models are precisely 19 / 20mm, your print may vary due to printer tolerances, filament used, and the quality of your MFT holes … so please don’t blame me for any discrepancies. Simply print and verify that it fits. If not, adjust the Y and Z axis scaling in your slicer and try again. Also, your filament’s flow rate might need tweaking.

Don't apply too high clamping forces unless you use a reinforced filament.