FN PS90 Trigger Overtravel Stop (Because I don't like being taken advantage of by P*****d Pawn)

So I love my little PS90. The trigger was not to my liking so I ordered a K&M Trigger Pack Spring and the P*****d Pawn Creep Killer II (unmodified hammer version).

I wouldn't normally freely release something someone put effort into designing but when paying $70 for a not clearly advertised as being a 3D printed piece (and very badly printed at that) I was not happy. I was expecting a machined component made from delrin, PEEK, Nylon, etc... for that kind of $.

So out came the calipers and remodeled it with a few minor tweaks.

I used a #47 drill bit instead of the hex key provided by the originator for getting the insert into place. Works like a charm and greatly improved the trigger feel.

Printed it in 100% Perimeters in Sainsmart PA-CF at 0.12mm layer height with a 0.6mm e3d obsidian nozzle on my Bambu X1C.