Bambu Lab AMS Feeder Button Cover

I don't know about you, but my purpose for using this AMS Feeder Button Cover is to make it easier to push and load / unload the filament (I never had problems with filament feeding without the button). All the versions I printed fit well but were always falling off when the spool is low or the retract of filament is in process. and that would cause issues for me. Adding the PTFE tube inside the opening didn't help either.

So I just redesigned it to still fit snugly on the button but open enough not to interfere with the filament loading / unloading process. And in the case it falls for whatever reason, (Didn't happen to me yet) you can get it out of the way without having it wrap on the filament spool.

If you like my design, Please buy me coffee.

I printed 4 up as in the picture without support. Good Luck. Printed on Bambu Labs X1C.

I don't know about you, but my purpose for using this AMS Feeder Button Cover is to make it easier to push and load / unload the filament (I never had problems with filament feeding without the button). All the versions I printed fit well but were always falling off when the spool is low or the retract of filament is in process. and that would cause issues for me. Adding the PTFE tube inside the opening didn't help either.

So I just redesigned it to still fit snugly on the button but open enough not to interfere with the filament loading / unloading process. And in the case it falls for whatever reason, (Didn't happen to me yet) you can get it out of the way without having it wrap on the filament spool.