Elegoo Neptune 3 (Reg, Pro, Plus, Max) E3D Hemera XS Revo Direct Drive Mount /w Beacon Probe Remix
Description
PDFUseful mount (remix) for the Hemera XS on the Neptune 3 Pro/Plus/Max. Used with the Beacon probe and original breakout board. The original file has perfect wiring set up and info. I used this blower, since I only wanted to use one 5015 blower (mainly for noise / performance ratio) https://www.printables.com/model/401961-hemera-xs-duct-bl-touch-mount/remixes.
Printed in ABS at Voron spec (40% infill, 4 walls, 5 top and bottom shell) with supports.
Tags
Model origin
The author remixed this model.
Elegoo Neptune 3 (Reg, Pro, Plus, Max) E3D Hemera XS Revo Direct Drive Mount /w Beacon Probe
Differences of the remix compared to the original
A few changes. Added a cutout to better access the POM wheel screws, or linear rail mount. Adjusted the heat set insert holes to better fit them.
Moved the break out board back a bit, to avoid shorts between the mounting bolt and breakout board. Reduced the area that the beacon mount sticks out, it's too tight a fit on my beacon (Rev D).
Added additional mounting points for rigidity, though after reprinting at Voron spec, this was rigid enough to not need it.
