Wireless charger Mobile phone stand - waves

I wanted to have a place for my mobile phone with the opportunity to charge it at the same time.

Threfore, I designed this model to fit a wirless charger plate form Ikea (https://www.ikea.com/de/de/p/livboj-ladepad-weiss-50457488/).

You can print it without any kind of support. 

You just need to press the plate into the hole at the back.

Recommendation: add the cable to the charger befor assemble.

Depending on your printer, you may need to sand down a bit the hole so that the plate fits perfectly.

Note: Note: I updated my version so the phone is standing 17mm higher. In the picture you see the stand with an extension.

Printparameter: 

Layer height: 0.2 mm
Line width: 0.4 mm 
Walls: 3
Infill: Cubic 15%
Support: no
Printtime: ~3 hours 30 minutes
 

Used Filament: Elegoo PLA+
Used Slicer: Orca 2.0.0
Used Printer: Elegoo Neptune 4 Pro

I hope you like it as much as I do!
In case you have suggestions for improvements, please contact me!