MFT GH201A slide-in Toggle Clamp Benchdog Adapter 19 / 20mm

This is a slide-in base for GH201A toggle clamps for 19 and 20mm benchdog holes

You can slide your toggle clamp in one of the three slots which gives you a wider range of clamping height. So no screws are needed!

PLA, print orientation as it comes from the STL file, use supports!

Caution: While the models are precisely 19 / 20mm, your print may vary due to printer tolerances, filament used, and the quality of your MFT holes … so please don’t blame me for any discrepancies. Simply print and verify that it fits. If not, adjust the Y and Z axis scaling in your slicer and try again. Also, your filament’s flow rate might need tweaking.

Don't expect high clamping forces, this is for fast fixing small things!