Sideways Angle Grinder Wall Mount Bracket

I needed to store my angle grinders better and all the models for mounts I could find fit them flat against the wall, which takes up a lot of space that I didn't have, so I made some that fit sideways with the handle pointed out.

There are two versions that should fit most 4.5" grinders (only with the shield installed, because you should have it installed,) the difference is the thickness of the portion of the mount that fits between the shield and the body of the grinder - v2 fits my M18 grinder and has a flange 4.5mm thick, while v3 fits the corded grinder and that section is 3mm thick.

These are designed to be printed upside down, with the opening against the print bed, to get the layer strength aligned nicely, I used PET-CF but a prototype in PETG seemed plenty strong enough, it should not require any supports. If you prefer to use the handle on the other side of your grinder simply mirror the part in your slicer.

The mounts attach to the wall with two or three #6 flat head screws, the bottom one requires a long driver to reach, but I tested with only the top two and that held just fine.