Ikea Skadis | T-Nuts | Many Knipex Pliers Holders
Description
PDFAkin to the original model: M2 T-Nut, M2 nuts and M2 12mm screws are needed for mounting.
Measure your pliers around the narrowest part of the handle (where they're mounted in the pics) to gauge if these will fit your pliers.
35mm: Tested working with Knipex 08 22 145 (Needle-Nose Combination Pliers) and Knipex 26 12 200 (Snipe Nose Side Cutting Pliers).
45mm: Tested working with Knipex 71 22 200 (KNIPEX CoBolt® Compact Bolt Cutters)and 74 05 180 (High Leverage Diagonal Cutter).
26mm angled: Tested working with Knipex 88 01 250 (KNIPEX Alligator® Water Pump Pliers) - please note the plier wont be mounted vertically, and is on a slight angle (see pic).
18/02/2025: Added 26mm vertical: Tested working with Knipex 88 01 250 (KNIPEX Alligator® Water Pump Pliers) - changed angle of holder for pliers to be vertically mounted on board.
18/02/2025: Added 31mm width with triangle: Tested working with Knipex 35 22 115 ESD (Electronics Pliers ESD) and Knipex 78 03 125 (Electronic Super Knips®).
28/02/2025: Added 35mm variant that works with Knipex 86 05 180 (Pliers Wrench Pliers).
Model origin
The author remixed this model.
Differences of the remix compared to the original
Adjusted width to suit other plier sizes.
