Follower - for Talon Springs - Sure.t Nerf Mod Talon Mag

Follower - for Talon Springs - Sure.t Nerf Mod Talon Magazine

A follower for standard Talon springs for the nice combination mod by Astropulse Sure.t Nerf Mod Talon Mag - Fully Printable - Quick Assemble/Disassemble
 

• I shortened the follower in height slightly and created more space between so that a standard Talon spring fits in. 
• Two small posts were added so that the spring has a better hold.
• I also adde a screw hole for 3mm screws (10mm long) in case someone wants to use this additional fastening (but it works nice without it too).

My print settings for PLA:

0,2mm layer height
5 Walls
at least 5 top and bottom shell layers
20% gyroid infill
NO supports needed

shortened the follower, added a screw hole, added spring posts, modified the follower and created more space to fit the standard Talon springs