Rubber Duck Fridge Magnets

This is a scaled down version of the Rubber Duck made by Wille on Thiniverse.

I have added a flat bottom and a hole for a 10*3mm magnet

It is recommeded to glue the magnet with some CA glue into the hole.

If your prints have an elephant foot inside the inner hole, take a sharp knive end remove the burr - then the magnet is press-fit

Print instructions

Unassociated tags: rubber duck

Category: Kitchen & Dining Print Settings

Rafts: Doesn't Matter
Supports: No
Resolution: 0,15 or better
Infill: 10% recommended

Notes:

Print in PLA, ABS, PETG or any other material. No infill needed, if the shell is at least 3 layers thick, otherwise us 10% infill.