Samsung Galaxy A12/M12 case

Peinted with silver PLA on carbon plate looks amazing but zero flex. Had to reprint in black PETG with less walls and its event better!

V2 printed in TPU

The v1 version is better even using petg

😎 little hard to put in using pla the v2

Printed in polymaker polyflex tpu 95. Feels a bit loose om the phone but otherwise fits. Will print again downscaled 1-2%

Hi, thank you for the great design.
Can you please upload a version where you add such structures between the long overhangs, i would like to try to print the case entirely out of tpu without support.
Thank you very much

Printed both versions, thanks.

Printed V2 in these filaments: Prusament Army Green, ProtoPasta Splittin' seeds gray, Prusament Royal Blue. Printet on textured sheet, 0.6 nozzle. (edited)

printed in abs and used a modifier so I could do the hex pattern on the back. Fit really well