Clip-on Flysky I6/I6X gimbal and Switch Protector

This is a gimbal and switch protector the the Flysky FS-I6X Transmitter. It clips on where the lanyard would go. It may work with the Flysky FS-I6 but I don't have a transmitter to test it on. If someone prints it for the I6 and it fits please leave a comment. This design was inspired by spudinator after making a protector that included switches. I still wanted more protection so I created this one with full covers and also wanted it to clip-on.

Edit 5-2-18: This does work with the FS-i6 as well, Thanks jos310581 for checking.

Edit 5-4-18: Added version without tops for easier printing and also uploaded a STEP file for easier editing if people want to customize.

Print Settings

Printer Brand:

Prusa

Printer:

No

Supports:

0.2 mm Layer Height

Infill:

Notes:

After printing I used a heat gun to bend the switch covers into place. I also used the heat gun to fit everything a little better to the controller. You can also use the heat gun to adjust the clip-on part to make it more snug if you prefer. Don't be heating it up while its on the transmitter either!rnrnPrinted Material: PLArnI will probably re-print this in PETG because I will know this will be sitting in my car and I don't want to worry about the the protector warping on a hot day.rnrn