Is it overengineered? Yes. Can you overengineer it even more?! definitely!
Requires a 3030 M5 t-nut and M5x12 screw, optional a 2.3mm wide cable-tie.
I wanted the x-axis motor cable to run close to the extrusion profile, thus I sketched this little thing. I also had too many M5 t-nuts here… If you think it is overengineered: yes it is and there are much more elegant designs out there.
For version v2, allow some more clearance for the screw. The design is on the very optimistic side for tolerances ;)
The author marked this model as their own original creation.