Golf - Golf Ball Holder - Clicgear cart accessory - holds divot fixer, tee and ball marker and with line stencil

This Golf Ball holder is to be used in conjunction with the clicgear v3.5 and up golf cart connectors on the side of the golf cart handles to provide additional storage for golf balls, divot fixer, tees, and a ball marker.  The bottom ball holder on this attachment has a triple line stencil that can be used to draw 3 directional lines on the golf ball to aid in putting.

Features

• Accessory for clicgear 3.0 and up version golf carts

• Stores up to 3 golf balls on the holder

• Stores a divot fixer (club off ground support holder or ball marker holder version)

• Stores up to 3 tees on the holder

• Stores a magnetic greens ball marker (2.4cm diameter)Lline stencil on bottom ball holder to draw line onto the golf ball to aid putting.  Recommend using a fine and/or ultrafine Sharpie marker pen or Milwaukee 48-22-3100 Inkzall marker pen for "Line" stencil imagery on bottom ball holder.

Printing Tips

• This model is optimized for an SLA printer but can be printed with an FDM printer

• requires supports and should be printed with impact resistant resin or filament for durability

• For SLA printing recommend 0.05mm layers with 100% infill

• For FDM printing recommend 0.15mm layers with 15% infill

Assembly

1. Post printing place 2  20mm x 2mm magnet (available at Amazon.ca) into slot under ball marker holder area.

2. Place plug into slot to cover magnets.

3. For SLA printed version use wet resin to fill in area above plug with thin film and cure.

4. For FDM printed version use superglue to secure plug

5. Sand down plug area until smooth with surrounding surface