Trim for 4th Gen 2024-2025 Toyota Tacoma Climate and Drive Control Knobs

Heads up: the knobs look the same size, but the drive knob is smaller by a hair!

Choose your filament and layer height to match your desired end quality. 

The bottom of each trim ring has tiny retention tabs. When installed the trim rings should be very secure, assuming your print settings are well calibrated.

I turned on ironing for top surfaces which produced a nice result with metallic PLA for climate knobs and PLA+ for the drive knob.

I recommend printing with tree supports. Because the top trim tabs are quite thin, I set top Z distance to 0.3mm and top interface spacing to 1mm. These settings made the underside finish slightly rough, but that will never be visible and I was very happy with the easy support release!

Let me know if you need any changes to the model.

If you have a new Tacoma, check out this phone charger pad too!