This picture frame is made from 3 parts that all snap together and is a double 2x3 frame. Just snap the front and the back into the holes with a bit of glue for extra strength and you're ready to load your photos. I used a .12 Fine layer height using PLA filament and a gyroid infill. The front piece sits flat on the build plate so it leaves a nice finish. I also used support but it was only used in the 3 holes on the back of the plate. You could probably get away with bridging there, but the support is so small and it pops right out. Let me know if you have any questions or ideas on how to improve this model. Thanks for looking and printing!!!
The author marked this model as their own original creation.