Charging stand for Carneo Guardkid+ 4G Ultra smartwatch

This stand has a slot designed for the magnetic charger connector and cable, providing a secure place to charge Carneo Guardkid+ 4G Ultra smartwatch.

Decorative Details: It uses pieces of 1.75mm filament as decoration. Cut the inner pieces to approximately 41mm and the outer pieces slightly longer, around 43mm.

Assembly Tips: If using PLA filament, place the pieces on the printer's heated bed at 80°C for a few minutes until they soften. Once softened, you can bend them as desired and insert them into the designated holes before they cool down. More flexible filament materials may not require heating for this step.

If the charger connector fits loosely, apply a small piece of masking tape around it to create a snug fit.