Minibar "Retail" Version V2

These files are for the Retail version V2 of the Minibar, from the Polybar & Minibar Project.

These files are for use with the “Polybar Mini Guitar Electronics Kit” found on Etsy here: https://m2torres3d.etsy.com/listing/1557624331

Printing:
Supports are not required if your objects are printed in the orientations shown in the images above. Make sure to print the files at a .2mm layer height, with 2 walls and a minimum of 5% infill.

Print Quantities:
1x of all shell pieces, 5x frets, 5x fret toppers, 2x pin retainer clips, 2x pins, 2x small buttons, 1x faceplate and 1x joystick cap.

Printing Tips:
Make sure the teardrop shape on the fret points upward for support-less printing. The shells don’t require supports at .2mm layer height, as the model has compensation for the openings where you install the screws.

Original design was by roadsidebomb, linked in the Model Origin below.
These 3D files were heavily modified to allow for easier printing and post-processing when using my custom parts kit.

Guitar Configurator by Sanjay900 can be found here: https://github.com/Santroller/Santroller/releases/tag/v10.1.271

Thanks Sanjay!
 

Things are easier to print and nothing needs supports. Also there's a lot of changes to work with my pcbs.