DJI Osmo Pocket 3 | Simple Grip System

I am going on a trip soon and wanted a simple grip that I could use with my DJI Osmo Pocket 3, and I couldn't find one. So, I went ahead and made one using parts from other models I found along the way (linked at the bottom).

This grip system is meant to be incredibly simple and not require any additional parts (unless you need the screw). The DJI will fit “snug” into it's holder, and if you need an extra level of security, there is a hole on the bottom-side for a screw to be inserted. 

If you print it, hope you like it! I may design and upload my own custom version in the near future, depending on how this trip goes. 

Parts List - 3D Files - a complete grip consists of:

• 1 x Osmo Pocket 3 Grip
• 2 x Osmo Pocket 3 Grip Cap

Parts List - not 3D Printed:

• 1 x M3 x 5mm
  https://amzn.to/3NTj8hw

---

Printing Instructions

I suggest printing the parts using the following settings:

• Layer Height - 0.2mm
• Wall Loops - 6
• Infill - 15 to 25%

3d Models Used

• https://www.printables.com/model/1022054-dji-osmo-pocket-3-video-grip
• https://www.printables.com/model/188386-dji-osmo-pocket-desktop-stand
• https://www.printables.com/model/3510-handle-grip

DJI Osmo Pocket 3 Video Grip | Just used as reference

DJI Osmo Pocket desktop stand | Embedded part into model

Handle grip | Embedded part into model