Benchy Boat Trophy - Riding the wave of success

As part of the “2024 3D Printing Industry Awards” competition, I created this wonderful trophy with the iconic Benchy Boat. The Boat is my model. 

With the idea of success, I came up with the concept of the boat riding the waves of success. I thought that was fitting for an awards ceremony. 

Also available are 1st, 2nd & 3rd prize models So you can use them for any awards show.

It is also available in a plain wave.

Print the boat and base separately, then glue them after printing. 

NOTE: Benchy model is not representative of a benchy “Bench mark” model. This boat model shouldn't be used for calibration and is just for the trophy only. Boat is scaled to fit 45mm limit of competition on the Binder Jet Part.

• The stand is approx 125mm High
• The Stand base is 80mm x 80mm
• The boat is non-uniformly scaled down from 3D Benchy to fit within the 45mm limit. 
• The boat can be attached using 2 qty 10mm x 2mm Magnet. 

I printed mine with 

0.2 layer Height

15% infill (increase for a heavier print to give you that award-quality feeling.)

Follow Link for Version 2