Pixel Watch 2 & 3 Charging Stand

Charging stand for the Pixel Watch 2 and 3.

The cable fits down the middle of the stand and the puck snaps into the top. Start with the wire in the slot and push down on the other side until it snaps in. The puck can be pushed out from the bottom with something long enough if needed. The dot indicates where the crown should be to align properly with the puck.

I attached it to my desk with Poster Putty.

Printed on a Prusa MK4 with 0.2mm layer height with a 0.4mm nozzle in PLA, any material should work if you factor in shrinkage.