Bag Clip w/ 6x3mm magnet slot

This is a simple remix of the neoyarus clip adding a slot for a 6mm x 3mm magnet.   You will need to pause the print in your slicer and add the magnet.*  For me, that was layer 20 w/ .2mm layers on Prusa slicer.

You can get the magnets for under $10US on amazon, search for 6mm magnet.  Take note of the height, as a 6x6 won't fit.  This remix was done completely in the slicer using a cylinder. It should be easy to do your own if your magnets are a different size.

I printed it w/ PTEG and a .6mm nozzle.

* Note on pausing… there is a common problem that a pause command will not reheat the hot-end after the pause if you are using octoprint.   I recommend using an SD card to print.  (or if you search there are recommended fixes. I haven't tried them as it was easier to just use an SD card. )

Happy Printing.