Samsung Watch 5, 5 Pro, 6, 7 Charger Holder Stand T-Clip Ikea Skadis

A holder for recent Samsung watches that uses the T-Clip system for pegboards like the Ikea Skadis.
3
23
0
167
updated November 24, 2024

Description

PDF

A holder for Samsung watches that allows you to charge it in a pegboard like the Ikea Skadis.

Printing instructions

This model should be printed with the T-Clip base perpendicular to the bed and the watch holder touching it. There are some thin lines in the base, so it is recommended to use an adhesion brim; tree supports are necessary for some roofs, but you may use support blockers on most overhangs and bridges if your printer can handle them (which most can).

Use ≤0.15 layer height, 20% gyroid infill, an adhesion brim and tree supports.

Depending on the tolerances of the rubber of your charger's cord, your printer, and spool, you may find that the cable fits too tightly (or not at all) down the holder; a cautionary +0.2 mm margin has been added to the model, but you might have to resort to a pair of pliers to enlarge the radius a few dozens of microns.

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

The watch holder from Dan's charger has been separated from the rest of the body, attached to a base with T-Clips, and the cable wrap has been completely reworked.

License