Small Quick Printing Box with Lid

This is my re-designed version of Jindřich Beneš "Rounded Bottom Box with Lid."  It is not a remix, as I modeled this from scratch in Fusion 360, but I took my inspiration from his design. 

Check his out if you haven't already. https://www.prusaprinters.org/prints/163-rounded-bottom-box-with-lid 

Dimensions are roughly the same, except I used much less fillet both inside and out and provide slightly more volume.  The latching mechanism is also re-designed to a simpler “ball and catch."

Prints in two pieces at slightly more than 1 hour.

Note: For the lid, print it with the latching mechanism towards the bed. 

12/27/21 Update: Added a new lid design.  

Requires no supports.