Weather station housing

Weather station housing for DIY weather station sensors. 

There is two versions. One with the holders and one without. 

Middle sections you could print as many as you need (example in the pictures has two). 

There is also a sensor holder that can be placed between sections to keep sensors in place inside the housing. 

Openings of the housing have grids to hopefully keep bees outside. 

For cables grid should be cut just enough to allow the cable room to go in, but not anymore, so hopefully those bees are staying outside.

M4 bolts and heat inserts were used to build the housing of the photos. Heat insert holes are sized for M4 heat inserts, but be aware that the walls are quite thin (maybe even too thin) so dont heat the inserts too much or the thin walls will melt and loose their shape.

If you printed the model, i would appreciate any feedback and/or “make".