Honeycomb Storage Wall Vertical Command Strip Hangers

These are single and dual cell wall hangers to attach Honeycomb Storage Wall panels to the wall using the half size Command Strips.  They are designed to hang off to the side instead of on top and bottom so the Command Strip is vertical, giving it the best holding power.

The single cell can be used anywhere along the side.  The dual is meant to be used at the joint between two panels to hold that “seam” together, and against the wall.

Of course, the part that clips into the HSW is based on the insert-empty.step model from the original Honeycomb Storage Wall model.  And by based on, I mean it pretty much is.  No.  I mean it is.

The part that attaches to the wall is based on the same part on the Command strip hanger for Honeycomb storage wall (now print in place) model.  I used my calipers to get the measurements and then just about duplicated that model, but I left off the small flange because I wasn't sure why it was there.

Fusion design files and 3MF files are included.

See this model for a remix of this remix that is for the longer Velcro like strips. 

This places the command strips vertically to give them better sticking power.