Filament Clip

Nice! THX

Really useful, printed using PLA

Layers: 0.28
Perimeters: 2
Infill: 15% gyroid
Material: ABS DevilDesign red (edited)

Printet very nice, Thanks

Perfectly usable, despite the foamy filament.
They fit all my spools and the filament side works really wel. My new go-to. (edited)

This is good only for half and more exhausted roll. Clip needs to much space inside a roll. (edited)

So far so good, I've printed a few different clips so far and haven't liked most of them, I got a couple more I'm going to check out too, but this one is going on the list of on of the good ones so far.

plenty sturdy for me, only suggestion would be to shorten the length of the part inside the spool, as the current length only works well with spools that've been going for a while

Bis jetzt funktioniert es sehr gut, wenn die Spule nicht voll ist