A Phone stand made with the pixel 8 in mind
0
7
0
107
updated January 27, 2025

Description

PDF

I wanted a stand for my pixel 8 and i didn't find a good one, so i made it.

Printing it on the side should work fine without supports, tested with neptune 4 and epla matte.

V3: Made the cutout for the charger a whole aperture, this allows for a better removal and placement of the phone while connected, but need supports, just a small filler between the aperture should work

 

i didn't make an hole on the bottom to pass the cable as i don't really like that solution, i may need to detach the charging cable from the stand so having them all weaved together is quite counter-productive for me

 

the phone is just slightly tilted so it can unlock with face when on the stand, plus the bottom lip is small enough to be able to use the home button, i have a case so without it you probably cannot reach it

 

i tested it with the Pixel 8, with an aftermarket cable which is quite thick, and that locks into place by friction, so you may have some slack at the charging hole with the stock cable, prob that is good for compatibility as having the connector/cable too close to the back side makes the phone tilt forward, leaning on the charger port, which is bad, so be careful to that :)

it may work with a wireless charger too, but i'm not sure.

 

Enjoy :)

Tags



Model origin

The author marked this model as their own original creation.

License