MagSafe Industrial IPhone Stand

I was immediately hooked by Josh_3D's industrial phone design. After a few weeks of using I knew I wanted to integrate apples MagSafe so I went about what I think is a good solution. 

Important Notes:

MagSafe chargers can get quite warm. The following parts should be printed in ABS, ASA, or other rigid and temp resistant material: 

MagSafeHolder_CableNut

MagSafeHolder_BoltSide

MagSafeHolder_BoltSide

MagSafe is held securely in place with a ZipTie wrapped around the holder parts. If possible i recommend using a ZipTie Tool. They are highly worth the investment for all projects outside of this one, however you can still firmly assemble the item by hand. 

Here is a closer view of the holder assembly. 

Hardware you will need:

M3 Nut, regular or Nyloc - 9x

M3 Bolt, 12mm - 4x

M3 Bolt, 25mm - 3x

M3 Bolt, 30mm - 1x

Zip Tie, ~4.5mm Width - 1x

Non Slip Rubber Tape for feet.

I welcome feedback and input for improvements to the design. More designs are coming so stay tuned.

New version is designed to hold a MagSafe Charger. I have kept as much of the features and dimensions compatible with the original design as possible. I made my own version of every part for maximum originality. Mix and match at your leisure.