reGoblin

Tried to give a more wood curved feeling to this one and aimed for realism.

The inside part of the frame, around the Goblin is empty and it will always match your wall colour :)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA BambuLab Basic Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA BambuLab Basic Gray
• PLA Overture Light Gray
• PLA Ziro Skin
• PLA BambuLab Basic Jade White

Swap Instructions:

• Start with Black
• At layer #8 (0.72mm) swap to Charcoal Black
• At layer #10 (0.88mm) swap to Cement Gray
• At layer #13 (1.12mm) swap to Sunlu Gray
• At layer #15 (1.28mm) swap to BambuLab Gray
• At layer #19 (1.6mm) swap to Light Gray
• At layer #22 (1.84mm) swap to Skin
• At layer #28 (2.32mm) swap to Jade White for the rest.