Photo frame 9"x9"

This is an 9" x 9" photo frame that prints in 8 pieces: 4 frame pieces and 4 clips.

I printed the frame portion face side down without supports and clips on their side with supports (see photos). The frame was printed in PLA and the clips in PETG. PLA was a bad material for clips in my testing as it permanently deforms under pressure.

You will need to cut some glass or plexiglass to size as well as a back plate. I used some scrap plexiglass for both the front and back plates.

You could remix this to make custom dimensions, which I may do in the future. If I make different sizes for the frames, I will update this thing.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

No

Supports:

No

15%

Filament: Amazon Basics/Overture PLA/PETG Black

Notes:

If I were to print this again, I would probably adjust the insert of the frame down 0.2-0.4mm so that the edges fit flush.