Failed until I added tree supports painted on.
I have the ode 2 so it's sloped, but it works!
Bellows for Fellow Ode
A bellows that fits into the fellow ode hopper. Use it to remove that last bit of coffee that otherwise gets stuck in…
16
212
2
3040
updated December 24, 2021
Makes
Comments
I tried 3 times print it. Two times with original stl with different setting but it failed at layer 54 and up. There was holes and it didn't keep it's form. I have Prusa and I think that this model needs supports but TPU is not good for that.
One time I tried to modified the model with RhinoCeros and make walls thicker but it didn't work out in printing. I would want to know how this is possible to print right. The TPU what I used was PrimaCreator's EasyPrint FLEX 95A.
I have tried to print this three times now and the same thing always happens which is that the single filament-wide section that makes up most of the print does not actually hold together. Essentially it is a bunch of strands of filament only connected at the corners. Any idea how to correct this?
@totalNewb2023_529371 Should be a double filament wide section all the way up. It's a tough print for me as well.
Made it one perimeter thicker inside (was having curling problems printing in TPU), and works like a charm!
Do you have any suggested print settings for this? I have had a couple of failed attempts at getting this to print so far.