LEGO Train Track Small Pieces 4 / 8 Long (L-Gauge)

Check out this new LEGO compatible train track!

• Fully compatible with LEGO train track (L-gauge) by pushing together.
• Studs can connect to other LEGO bricks.
• All designed in SolidWorks to be as close as possible to the original LEGO track shape - including all fillets/chamfers/sizing.

These models are for straight track, either 4 studs long or 8 studs long. Which correspond to a quarter of a standard LEGO straight track, or half a standard LEGO straight track.

Print Settings:

1. Supports will be needed at the ends of the rails at each connection, I use paint on supports with “Smart" fill and it works perfectly.
2. I have had success printing this in PLA with standard “generic PLA IS” settings, however the first layer must be slowed down considerably to prevent warping of the smaller parts - therefore I would recommend 15 - 25% speeds for the first layer. 
3. I've also found no fan for the first 10 layers helps to prevent warping, but this can be experimented with.
4. If all else fails, a brim will ensure adequate adhesion.
5. Hope this helps, and happy printing!

My print files are included which I have had success with! :-)