Wheeljack's Treads from Transformers Skybound Comics

Still massively injured from the Ark's crash, Wheeljack heroically chose to patch up his comrades before his legs and opted to get this still awesome treads to help him get around for now.

Rocking these self made treads, Wheeljack is armed with a handy keypad on his side to llkely control its movement and also probably some stuff around the Ark!

On the opposite side of the keyboard, a similar 5mm port has been designed in to allow the option for storing accessories to adding on effect parts.

Here's Wheeljack hanging around with his pals, Cliffjumper and Jazz, just to help give a sense of how he scales up with them too.

=== Adjusting the torso angle ===

To help rotate and angle Wheeljack's torso, just lift the SphereRing up to loosen the grip on the "Sphere", angle or tilt Wheeljack's torso to the desired position, then firmly press down on the SphereRing to tighten and lock the angle in place!

And this should help lock and hold Wheeljack's torso securely in place!

=== Switching from Wheeljack's legs to his treads ===

Here are the steps to connect Wheeljack to his treads. To take off his legs, firstly remove his chest plate by lowering it and slowly guiding it out forward.

Once the chestplate has been removed, Wheeljack's lower torso can be carefully removed but rotating and nudging it out forwards.

And then the printed Waist part can be attached on doing the same in reverse and replacing the chestplate.

=== Assembly ===

The attached diagram shows the schematic of the parts for this kit and how they are supposed to be assembled.

Just a special note about putting together the middle assembly, you will need to pass the top part of the "Sphere" through the "SphereRing" before connecting it to the Waist" piece. Do note that it should be oriented with the inner part tapering upwards.

---

Hope everyone would like this conversion kit for WFC Wheeljack to recreate his Skybound comic version with treads.

Happy 3d printing! =)