SB2209/SB2240 - CW2 Cable Bridge, PG7 w/ Cutout for Can Cable

Low profile and Centered PG7 Toolhead mount. Now with a cutout!
10
37
1
249
updated October 20, 2024

Description

PDF

Different take on CANbus cable strain relief using PG7 Gland.
Intended for newer BTT Toolhead boards with thicker connector.

For those who want lower and centered mount with a cutout for the cable/screw in portion. Make sure to route the cable in the slot near the “corner” of the bracket before installation.

I didn't get a photo of it before I installed it, so the required photo isn't great at showing what I did but check the model and you will see.

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

I added in a cutout behind the PG7 threaded area to make installing/removing the cable easier. So far holding up just fine. It feels just as rigid as the original once installed. The PB7 gland and the USB-C support make it pretty rock solid.

License