Very simple but effective air jet tool to connect to airbrush for cleaning, blowing out objects, like cleaning an RC Buggy after use ect …
Very simple model starting with a 1/8 BSP thread to connect to most airbrush compressors, the nozzle ends in a 1mm hole, if the hole is not nice at the very end due to print wobble you can cut it back with a sharp knife until you have de diameter you feel fine with.
To avoid wobble irregularities use a good raft as a print base that sticks the model very well and solid to the raft and be patient and print at slow speeds for best results.
Layer height 0.16mm, 100 percent infill, whatever material you want.
In the picture the print is already a bit damaged and dirty as I started to use it right away :)
The author marked this model as their own original creation.