Pumpkin K-cup Holder

This is a k-cup holder I designed to spice up my counter and to put a little fall atmosphere in the house. Ideally it would be pumpkin colored but I only had grey filament so I'll just have to paint it. 

Stores up to 9 cups at a time. Lip inside that will lock the top part of the pumpkin in place

Must be printed no smaller than original size for the cups to fit right 

10% infill on bambu labs p1s. Supports needed.

(Bottom is a little rough but it unnoticeable when sitting flat.) 

If you would like to support me or sell printed out versions of this ghost check out my patreon: https://www.patreon.com/c/bigtaterprinting/posts