Fysetc led holder for Bambu Lab X1C P1S P1P

Made this FYSETC single led holder for the set I bought from amazon (link below).

The holder is HxWxL 15.4x12x80 (mm)

It is angled 20 degrees down and the area very good.

I personally left the original light and added just one led part and its night and day.

In my opinion its enough (for me) :)

BUT, if you need to put all 3 of them just print 3 of these and just stick them to the metal frame.

You will need some VHB tape to attach the holder to the metal frame inside.

link to the Fystec leds (its an affiliate link, would gladly appriciate of you'd order from it ^^ )

||||||

v v v v v

https://www.amazon.com/dp/B0D5B4W3DH?tag=xpertengineer-20

before install:

after install: