Plague doctor mask mesh goggles

Added a 0.2mm layer covering the eye. This is done entirely in Orca slicer.

Set top and bottom layers to 0 for the mesh part only, and play with grid infill percentage for desired effect. Reduce sparse infill line width to 0.4mm on a 0.4mm nozzle.

I found that 50% infill gives a nice tradeoff between obscuring the eye while not reducing vision too much.

And I also added my .3mf file of the mask itself, on which I painted support blockers such that only the forehead is supported. I recommend using regular tree style support instead of “strong”, as this did not print well. But it was fast and it did work for me.

Added infill mesh to the goggles