MK4S xLCD original Prusa enclosure holder - for moulded version

The adapters that are available are a disaster. Maybe on purpose to stretch our creativity and strength and create something nice for the community.

So here I bring a nice holder that will certainly not offend anyone.

All fasteners are original Prusa, so you don't need to buy anything extra.

Assembly procedure:

1. Disassemble the xLCD holder on the enclosure. Leave the ground cable and the xLCD cable connected.
2. Pre-cut a thread into the printed holder with an M3 screw (this is for easier subsequent assembly on the enclosure).
3. Screw the xLCD panel to the holder using 3x12sT screws (4 pcs).
4. Screw the holder with xLCD panel to the enclosure with the M3x8 screw (3 pcs).
5. Enjoy a nice holder. I almost forgot, if you have any Haribo bears left, please share.

If you have an Original Prusa Enclosure in its original design, there remains a small gap between the xLCD panel and the surface on which the enclosure stands.