Lancer hotend (Lancer Melt Zone) mount for ENG v1.2

Lancer hotend(standard version) mount for Ender 3 NG v1.2

You must cut the top tube shorter than the length specified below.

The copper tip can be removed by heating it.
Then cut the tube and reinsert the copper tip.
(remember to clean the metal debris inside the tube)


It has the same nozzle height as the L series of ENG toolhead (ducts, and probes should work)

Instead of M2.5 screws, Lancer requires M3 screws to mount the hotend.
This model is intended to use 4 * M3x6mm for that

intended print orientation

added Lancer hotend mount