Nibbi Carburetor Choke Cable Adapter

Adapter I created to connect an existing choke cable to a Nibbi carburetor choke plunger. Print with ABS or other filament with high temperature threshold as this part will be exposed to heat. Probably wouldn't be a bad idea to wrap some heat shielding around it.

Printed at .15mm layer height with 0.4mm nozzle. May require using a razorblade or scalpel blade to remove a small amount of plastic from the opening for the plunger as it needs to be a very tight fit. It's intentionally tight and will require a good amount of force to insert it.

NOTE: You will need to modify the plunger by sliding the rubber boot up and using a blade or flush cutters to clip the 4 plastic tabs off that hold the plunger up by snapping into place under the ball on the plunger rod. You can see from one of my photos where those tabs have been removed. If you're not sure what I'm referring to, compare the photo of the 3D model with the photos I took of the choke plunger and you'll see the tabs that are missing.