Chain candle stand (no supports needed)

A support-free simple yet cool looking candle/tealight holder for decoration. Three heights available.

WARNING: Do not use with real candles! They could heat the stand enough to melt and cause a fire hazard. Use electric tealights instead.

Features

• Printable without supports
• Beautiful chain texture
• Three heights: 5cm/7.5cm/10cm
• Cool Halloween decoration
• Fits every candle/tealight with a diameter up to 37mm
• Find my recommended tealights here (affiliate link)

Recommended print settings

• Layer Height: 0.2
• No supports needed
• Wall Loops: At least 3 (for better stability of the chain)
• Infill pattern: Gyroid (to reduce the risk of catching the nozzle in the model and breaking it)
• Infill combination: Disabled (to reduce risk of catching the nozzle in the infill)
• Print on CoreXY if possible (bed slingers have a higher chance of failure when printing wobbly models)
• Z-Hopping: Enabled (lower the risk of catching in the model)

You like my work? Consider to buy me a coffee :D