Asus-VG27AQ1A Power Supply Holder

Files:

• v3 is for bricks that are 7.5cm x 7.5 cm and older. It has only one lip, because I'm to lazy to backport the second lip to the old version.
• v4 is for bricks that are 6.5cm x 6.5 cm and newer. It has two lips. The fit is a bit tight, maybe print it 102%.

Print:

• PETG / PLA+. Use a filament that is a bit more heat resistant because this bricks can run hot.
• Infill irrelevant, solid layers in this side.
• I've printed it in 0.3mm with a 0.6 nozzle

Mounting:

• I've used wood screws M4x50, maybe M4x40 will work, but they are short.
• The tubes are only guides for the screws, the screws are not tapping the tubes