Pocket Operator Case by Vision 11

For the case you will need 4 M3Bolts (2x 20mm long and 2x 10mm long). There is a top plate for every screw type of your choosing.

There are two bottom half variations. One blank and one with a loop for a lanyard or strap to fit through.

To add the screen guard you will need some glue of choice.

All the special buttons have quite small details and are best printed with a 0.2mm nozzle and 0.08 layer height (for a clean look I recommend doing a filament swap for the top layers).

To reduce rattling sound you can add some padding unter the buttons. I did that by adding a small piece of electrical tape underneath.

The tolerances are quite snug but on my BambuLab A1 the cases fit without trouble.

If you encounter any problems while printing please let me know so I can tweak the model.

Have fun printing and thank you for your purchase :)