This is a trampoline spacer, used to hold the net support arms to the frame. I built this model to print after a wind storm damaged our trampoline. Ours was purchased from Sam's Club.
Printer Brand:
LulzBot
Printer:
TAZ 5
No
Supports:
Yes
20%
Notes:
This model should be layed flat against the bed. Printed in natural PLA with supports only touching the bed (no need for supports inside the tube).
The design was done in OnShape, and can be seen at:
https://cad.onshape.com/documents/fdc4c9a07cf2a0f0b3617e84
The author marked this model as their own original creation. Imported from Thingiverse.