Filament Reel relocator for Sovol SV08 - Updated minimalist version V2

This remixed model allows you to move the filament reel and the filament sensor lower down the side of the printer. It reduces the overall height and width of the printer. 

It uses the stock spool mounting parts plus one 10mm wood-screw to mount the filament sensor and 2 wood-screws (10-12mm) to mount the stock spool holder to this part.

Recommendation: To avoid unspooling add additional mod to make the ball bearings not rotate anymore. https://www.printables.com/model/941785-sv08-spool-holder-spacer-mod

Made a remix:
Minimalist version - less filament required, prints in less than an hour on SV08.

No threaded inserts required, 3 additional 3-3,5mm / 12mm wood screws will do.

Info: Best use with spool holder spacer mod to avoid filament tangle.

https://www.printables.com/model/941785-sv08-spool-holder-spacer-mod

V2 released: filament runout sensor placement lower. This will avoid sharp angle and avoid occasional scratching noises from filament entry hole.