The Owl House Porta-Hooty

Model of Porta-Hooty from The Owl House.

Hooty has an articulated neck.

The length of Hooty depends on the number of segments you print.

There is also a version with a fixed Hooty.

Print Instructions

General Instructions

Everything was printed at 0.2mm layer height. No supports required.

You can either print the house with fixed or flexible Hooty.

• Fixed:
  • “porta-hooty fixed”.
    • adaptive layer height recommended.
• Flexible:
  • “porta-hooty roof”
    • print in red
  • “porta-hooty house”
    • uses filament changes
    • initial: white
    • 33m: gold
    • 33.4mm: white
    • 34mm: red
    • 34.4mm: gray
    • 34.8mm: gold
  • “hooty head”
    • brim recommended
  • “hooty segment”
    • brim recommended
    • print as many copies as you want
  • “hooty end”

If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#

Used the body of the Big version for Hootys neck