Vampire Cat

Another year comes and we proudly present another cat in our loose series of Halloween cats and kitties - the VAMPIRE CAT.

Again printed in two parts. One part is the body, second part is the cape.

The body is printed with minimal support, only the bow tie needs support and optionally the teeth (but should be fine without teeth support).  No infill needed. In the PrusaSlicer project I used random seam and used seam painting to keep it away from the face. 

The body is printed in white PLA (Prusament Pristine White) and finished with red and black markers. If you have multicolor printer, the stl can be broken into parts and then you can print eyes, orifices and the bow the in respective color (sadly I do not have multicolor printer to test it).

The cloak is printed in vase mode so no pesky seams to deal with. Printed in red PLA, used black marker to make the outer side black while keeping the inside of the cloak red.

Printed on Prusa Mini+, it took about 3hours for both parts.

P.S. If you like this design, you can also check my older Halloween cats - https://www.printables.com/cs/model/85388-pumpkin-cat  and https://www.printables.com/model/596636-ghost-kitty.