Honda Odyssey FOB

Replacement casing for Honda Odyssey 2012 Key FOB.

The metal key broke out of the case, but was still perfectly good.

This new case has 4 pins to align and press fit together after adding a perimeter of super glue. Clamp closed for a couple hours to allow glue to fully cure.

• Printer brand:

Bambulabs

• Printer:

Bambu X1C

• Supports:

Yes

• Resolution:

.08mm

• Infill:

50% rectilnear

• Filament brand:

Generic

• Filament color:

Black

• Filament material:

PLA

• Notes:

Printed top (finished) side against the bed.

Used Hilbert Curve surface pattern for the bottom surface patterns to leave a more decorative look.

I replaced the screw requirements with 4 alignment pins that allow you to press fit the case together after adding a perimeter of super glue.  The case was also reduced in size and thickness.

The super glue seal does mean you will need to break apart the case to access the components if you ever need to change the battery, but it allows for a much smaller profile which is a good tradeoff.